Arduino for HP step attenuators                           April 23, 2016

HP 33320, HP33321, HP 33322

By Alain Fort F1CJN

 

******************************** FRANCAIS ********************************************

 

Ce programme utilise un Arduino Uno muni d'un "LCD button shield V1.0" de marque ROBOT, avec boutons, ce qui permet de commander l'atténuation des atténuateur HP.

Le montage utilise un circuit ST L9822 pour piloter les atténuateurs. La tension de controle doit être celle indiquée sur l'étiquette de l'attenuateur (5V à 24V selon les modèles).

 

                          

 

 La valeur de l'atténuation est sélectionnée avec les touches UP and DOWN.

 

LCD

 

********************************ATTENUATEUR**************************

HP_33321SC

 

***********************************SCHEMA*****************************

 

schema

 

************************Software, schématic and L9822 datasheet***********************

 

Suivre le lien:HP_Attenuators.zip

 

************************************ ENGLISH ****************************************

 

 This sketch uses and Arduino Uno (5€), a standard "LCD buttons shield" from ROBOT (5€), with buttons to select the attenuation value and a ST L9822 circuit to drive the attenuator.

The attenuation value is selected with the UP and DOWN buttons.

The driving voltage of the attenuator is written on the attenuator body (5V to 24V).